![]() ![]() Next, frame the Frame the shed walls based on 16″ O.C. To frame a modern shed, start with a solid shed base and durable plywood subfloor. Although shed wall framing will be similar for many shed sizes and styles, this guide will focus on a 10’x10′ modern shed with a lean-to style roof. O’Neill Company provided expert assistance with this segment in Lexington, MA.When building a shed, framing the walls is typically one of the most critical steps in the shed construction process. All of these items are at home centers and lumberyards.Ĭ.R. To secure the boards together, the team used a variety of framing nails with a nail gun. To frame the new barn, Tom and the rest of the team used a combination of 2×4″ stock framing lumber for the studs and 2×6″ stock framing lumber for the roof rafters. Nail through the last stud on each end of the shorter walls and into the inside corners of the longer walls. Repeat the process with the other long wall and then with the two shorter walls.Use scrap lumber nailed to the side of the wall to steady it. Using the framing nailer, nail through the bottom plate and into the pressure-treated lumber. With help, lift the wall from the top and position it on top of the pressure-treated lumber.Also, at each end, nail an additional stud turned perpendicular to the other studs to form an inside corner. Repeat the process with the bottom plate, driving two nails through the bottom plate and into the king and jack studs.Also, nail through the sides of the jack studs and into the king studs and through the sides of the king studs into the sides of the header. Drive two nails through the top plate and into each of the king studs.Holding the headers in place, use the framing nailer to nail through the top plate and into the top of the headers.Each header needs to consist of 2 2x8s cut to the appropriate length (the distance between king studs), with a piece of ¾-inch plywood sandwiched between them. Place the king studs on the Xs and jack studs on the Os. Starting with one of the long walls, spread the top and bottom plate apart on the shed’s floor.Mark header locations for windows and doors on the top plate, as well. For shorter studs that support headers (“jack” studs), make the locations with Os. For full-length or “king” studs, mark the locations with Xs. Stack the top and bottom plates together and mark them for studs spaced 16 inches on center.The long walls will run all the way through from corner to corner of the foundation, while the shorter walls will be between them. Cut the top and bottom plates for each wall to length.Attach it to the foundation by drilling through the pressure-treated lumber and into the foundation, securing them in place with concrete anchors. Measure the lengths of the foundation walls and cut pressure-treated lumber to length.Going off the plans, you can cut all the different studs and plates using a circular saw or miter saw and lay everything out on the ground to ensure everything has been cut perfectly. Sheathing – the plywood that closes the walls in.Cripple Stud – a stud that supports the framings of openings both on top and underneath the opening.King Stud – a stud that supports the jack stud and runs the entire length of the wall top to bottom. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |